Digi TransPort - Page 546

Configure X.25 parameters
Digi TransPort User Guide 546
10 Line Folding
Controls the automatic generation of a [CR],[LF] sequence after a certain line width has been
reached.
11 Port Speed
This is a read only parameter, set automatically by the PAD and accessed by the remote
system.
12 Flow Control of PAD (by DTE)
Determines the flow control setting of the PAD by the DTE in the on-line data state.
13 LF Insertion (after CR)
Controls the automatic generation of a Line Feed by the PAD.
The line feed values can be added together to select Line Feed insertion to any desired
combination.
Option Description
0 No line folding
1-255 Width of line before the PAD generates [CR],[LF]
Option Description
15 19,200 bps
14 9,600 bps
12 2,400 bps
3 2,400 bps
Option Description
0No flow control
1 XON/XOFF flow control
3 RTS/CTS flow control (not a standard X.3 parameter)
Option Description
0 No line feed insertion
1 Line Feeds inserted in data passed TO the DTE
2 Line Feeds inserted in data received FROM the DTE
4 Line Feeds inserted after CRs echoed to DTE