Configure X.25 parameters
Digi TransPort User Guide 547
14 LF Padding
Some terminal devices, such as printers, require a delay after each Line Feed before they can
continue to process data. This parameter controls the number of padding characters
(NUL-ASCII 0) that are sent after each [LF] to create such a delay.
15 Editing
Enables (1) or disables (0) local editing of data input fields by the PAD before data is sent. The
three basic editing functions provided are character delete, line delete and line re-display.
The editing characters are defined by parameters 16, 17, and 18. In addition, parameter 19
determines which messages are issued to the DTE during editing. When editing is enabled, the
idle timer delay (parameter 4) is disabled, and parameter 3 must be used to select the desired
data forwarding condition.
16 Character Delete Character
The edit mode delete character (ASCII 0-127). The default is backspace (ASCII 08).
17 Line Delete Character
The edit mode line buffer delete character (ASCII 0-127). The default is CTRL-X (ASCII 24).
18 Line Redisplay Character
The character that re-displays the current input field when in editing mode (ASCII 0-127). The
default is CTRL-R (ASCII 18).
19 Editing PAD Service Signals
The type of service signal sent to the DTE when editing input fields.
Option Description
0 No line feed padding.
1-255 Number of NUL characters inserted after LF
Option Description
0 No editing PAD service signals.
1 PAD editing service signals for printers.
2 PAD editing service signals for terminals.
To Next Page
Loading...
