Digi TransPort - Page 562

Configure X.25 parameters
Digi TransPort User Guide 562
Stored X.25 PAD profiles are held in non-volatile memory, and are not lost when the router is
switched off.
When used in the format:
prof nn
the PROF command loads the stored profile specified by nn.
RESET command: Send reset packet
RESET issues a reset for the current call to the network. It does not clear the call, but it does
return the network level interface to a known state by re-initializing all Level 3 network control
variables. All data in transit is lost.
RPAR? command: Read remote X.3 parameters
RPAR? lists the current X.3 parameter settings for the remote system.
RSET command: Set remote X.3 parameters
RSET sets one or more X.3 parameters for the remote system. It is entered in the format:
RSET par #:value[,par #:value[,par #:value ...]]
SET command: Set local X.3 parameters
SET sets one or more of the local X.3 parameters for the duration of the current session. The
format of the command is:
SET par #:value[,par #:value[,par #:value ...]]
STAT Display Channel Status
STAT displays the current status for each logical channel indicating whether it is free or engaged.
For example:
stat
PAD STATE
1 ENGAGED
2 FREE
3 FREE
4 FREE
19 2 2 1 1
20 64 64 0 0
21 0 0 0 0
22 0 0 0 0