View network interface status
Digi TransPort User Guide 731
View the IP routing table
The IP Routing Table page displays the IPv4 routing table.
Destination
The destination IP network of the route. The destination needs to match the destination IP
address of an IP packet for the route to be used. For default routes, the destination IP network
is always 0.0.0.0/0. Default routes are used when no other route matches the destination IP
address of an IP packet.
Src Addr
When source address routing is being used, the Src Addr value needs to match the source IP
address of an IP packet for the route to be used.
Gateway
The IP address of the next router to which the IP packet will be routed to in order to reach the
destination network. On PPP and TUN interfaces, and ETH interfaces that have the gateway
configured, this parameter can be blank.
Metric
The route metric defines the cost of the route. If CIDR routing is enabled and there are two
routes to the same destination, the route with the lower metric is used.
To Next Page
Loading...
