C
HAPTER
3
| Using the Web Interface
Navigating the Web Browser Interface
– 98 –
Chart Shows Interface, Etherlike, and RMON port statistics 156
Green Ethernet Adjusts the power provided to ports based on the length of the
cable used to connect to other devices
176
RSPAN Mirrors traffic from remote switches for analysis at a destination
port on the local switch
152
sFlow Configures flow sampling for source and destination ports 178
Configure Global Enables sFlow globally for the switch 179
Configure Interface Configures flow sampling for source and destination ports 179
Traffic Segmentation 181
Configure Global Enables traffic segmentation globally 181
Configure Session Configures the uplink and down-link ports for a segmented group
of ports
183
VLAN Trunking Allows unknown VLAN groups to pass through the specified
interface
185
VLAN Virtual LAN 187
Static
Add Creates VLAN groups 190
Show Displays configured VLAN groups 190
Modify Configures group name and administrative status 190
Edit Member by VLAN Specifies VLAN attributes per VLAN 193
Edit Member by Interface Specifies VLAN attributes per interface 193
Edit Member by Interface Range Specifies VLAN attributes per interface range 193
Dynamic
Configure General Enables GVRP VLAN registration protocol globally 197
Configure Interface Configures GVRP status and timers per interface 197
Show Dynamic VLAN 197
Show VLAN Shows the VLANs this switch has joined through GVRP 197
Show VLAN Member Shows the interfaces assigned to a VLAN through GVRP 197
Tunnel IEEE 802.1Q (QinQ) Tunneling 200
Configure Global Sets tunnel mode for the switch 204
Configure Service Sets a CVLAN to SPVLAN mapping entry 205
Configure Interface Sets the tunnel mode for any participating interface 207
Protocol 209
Configure Protocol 209
Add Creates a protocol group, specifying supported protocols 209
Show Shows configured protocol groups 209
Configure Interface 211
Add Maps a protocol group to a VLAN 211
Table 6: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
