APPENDIX B : A--SERIES AIR DRIVEN AIRDRYER
20951 Issue 1 Apr 98 B--9
Airdryer -- Installation
CAUTION The airdryer must be mounted in the vertical
position.
Theairdryerhas keyholeattachmentpointsalongits top edge. Ensure
that the airdryer is secure when attached by these points.
The airdryer contains two fuses in inline holders in the wiring to the
isolator. Remove the cover and check that the fuses are correct for the
nominal power input (240V -- 1A, 120V -- 2A). Replace the cover.
The airdryer connections (see diagram pg. B--8) are as follows:
(a) Power supply cable -- connect to the power source.
(b) Power cable to printer -- connect directly into the airdryer
power socket.
(c) Air supply input -- connect to the factory air supply.
(d) Air supply output -- connect to the printer at the connection
near the conduit panel at the side of the cabinet.
Mounting the Airdryer onto the A--Series Stand
WARNING: Power to the printer must be removed.
(1) At the rear of the A--Series stand, screw the two M6x10 skt cap
screws into the centre holes of the rear support panel. Allow
sufficient room for the airdryer slots.
(2) Fit the airdryer onto the screws using the two outer keyhole
fittings.
(3) Tighten the screws to secure the airdryer in place.
(4) Remove the mains cable from the printer.
(5) Plugtheairdryermainsoutputsocketintotheprintermainsinput.
(6) Connectthe2metresof1/4” tubesuppliedinthekittotheexternal
festo on the side of the printer (below the external connections).
(7) Cut this 2 Metre tube to the correct length, and connect the other
end to the airdryer air output festo.
Notes (1) Ensure the tube is not kinked.
(2) Test the air supply and humidity at the printhead using the
airdryer test kit -- part number 30455.
(3) If the airdryer air output is not connected to the printer, an air
pressure fault will occur
To Next Page
Loading...
Need help?
General
