OPERATION
27080 Issue 1 August 98 3--13
To Create a Machine Readable Code (MRC) (A300/A200
only)
The following procedure is carried out in Message Editor, either as a
new message or as part of a message being constructed.
During the following procedures, decisions on the following will be
required:
(a) MRC type
(b) MRC data which is appropriate to the MRC type
(c) Positionofany human--readabletextrelatedtotheMRC. This
is usually indented into a barcode, but can, if required, be
placed elsewhere.
(d) Type of human readabletext. Thisisusually the same dataas
the MRC and, ifset upaccording tothe followingprocedures,
amendmentsorupdatestotheMRCwillthenbeautomatically
applied to the human--readable text.
During the procedures, key labels along the bottom of the screen may
not show the required options. It will be necessary to be familiarwith
using the scroll keys (see pg. 2--12) to move the key options across the
screen and selecting an option by pressing the key below the label on
the screen.
It will also be necessary to be familiar with using the up-- and
down--cursorkeys tomovethehighlightbarto select settings givenon
a display screen.
(1) Inspectthecursoronthe displayandpresstheFontSizeoptionkey
until it is the size of the required MRC.
(2) SelectStartMRCoptionkeyandnotetheappearanceofthesymbol
”>” at the correct MRC size.
123456
Indentation
Width
Quiet Zone
(Right)
Quiet Zone
(Left)
Barcode
Size
(Lines)
Height
(Lines)
Font
Size
Start
MRC
To Next Page
Loading...
Need help?
General
