OPERATION
3--16 27080 Issue 1 August 98
To Create A Dot Code:
Followstepsunder’CreateaMachineReadableBarcode’uptostep(5),
then continue as follows:
(6) Select therequiredcode (SnowflakeorDataMatrix) and press the
Advanced key.
(7) Select the required Dot Code parameters in this screen. These are
as follows:
Formatwhichdescribesthetypeofdatatobeencoded,optionsare:
SNOWFLAKE DATA MATRIX
1. Numeric only (0..9) 1. Numeric only (0..9)
2. Upper case only (A..Z) 2. Alpha only (A..Z)
3. Lower case only (a..z) 3. Printable ASCII
4. Punctuation (;:’,.?!)
5. Alphanumeric (A..Z a..z 0..9)
Error Correction Code (ECC) appliedto dotcode. Usethehelp(?)
to enter the required ECC for Snowflake, values of none and
checksum are not permitted and will be changed to theminimum
supported value of 10%. For Data Matrix, ECC values of 000, 010
and 040 are not supported and are changed to the minimum
supported value of 050. The reason that numbers areentered is to
make the menu generic for all dotcode symbologies (see the
following Help screens).
(8) Select the height and width required and press OK.
To Next Page
Loading...
Need help?
General
