DISPLAY MESSAGES AND FAULT FINDING
27080 Issue 1 August 98 4--15
Modulating
The printer has entered an intermediate state where the jet is
running and modulation is enabled. This intermediate state is
only reported when sequencing is controlled via the Service
Mode.
Modulation reset
The printer is attempting to automatically reset the modulation
level.
Phase locked
The printer has entered an intermediate state where the jet is
runningandthephasecontrolhasbeenlocked. Thisintermediate
state is only reported when sequencing is controlled via the
Service Mode
Printer Off
The printer’s inkdelivery system is fully sequenced off. Theink
is not pressurised. (This is one of the possible states that printer
can enter when first turned on -- the other is Printer Standby).
Printer Initialising
The printer is initialising. This may take several minutes if the
printerhasbeenreconfiguredtooperateusingdifferentoperating
parameters, e.g. the ink type, nozzle size or print format has
changed.
Printer Standby
The printer’s ink delivery system is sequenced off but the ink is
pressurised. (This is one of the possible states that printer can
enter when first turned on -- the other is Printer Off).
Printing Disabled
Printing has been disabled -- see Enable Printing in Print Setup.
Ready to Print
Theprinterinkdeliverysystemisfullysequencedonandisready
to print. This is the state the printer reports when actually
printing. Indication of actual printing is made by the ”printing”
symbol to the immediate right of the printer status line.
To Next Page
Loading...
Need help?
General
