DISPLAY MESSAGES AND FAULT FINDING
4--14 27080 Issue 1 August 98
STATUS BAR MESSAGES
Status Bar
The following status messages may be displayed:
Fault condition
Theprinterencounteredafaultthatitwasunabletorecoverfrom.
In general, this state is entered after the printer has shut down
followinganunsuccessfulfaultrecoveryattempt. Pressingthejet
On/Off button for 2 seconds resets the printers status to ”Printer
Off”. The printer or print head may require cleaning or other
maintenance before attempting to start up again.
Fault recovery attempt
The printer has encountereda fault that it may be able torecover
from and it is attempting to do so. Please wait until the printer
reports ”Ready to Print” indicating that recovery was successful
or the printer aborts the recovery attempt and sequences off.
Head bleed in progress
The printer is performing a printhead bleed operation. This isa
service level operation.
Heating, please wait
During sequencing on, the printer has determined that the
gunbody in the print head has not yet reached the minimum
operating temperature for the type of ink in use. Once the
required head temperature is reached, the printer will report
”Sequencing On” and continue until ”Ready to Print”.
Jet running
The printer has entered an intermediate state where the jet is
running,butthereisnoHV,jetmodulationordropcharging. This
state is only reported when sequencing is controlled via the
Service mode.
To Next Page
Loading...
Need help?
General
