Short thread cutter
Service Instructions 1767 - 00.0 - 12/2016 87
Setting the cutting pressure
Cover
• Open the throat plate slide ( p. 21)
Fig. 70: Setting the cutting pressure
To set the cutting pressure:
1. Swing out the thread-pulling knife (1) until the marking (2) is next to
the cutting edge of the counter blade (5).
2. Loosen the screw (6).
3. Place the counter blade (5) in position against the thread-pulling knife (1).
4. Tighten the screw (6).
(1) - Thread-pulling knife
(2) - Marking
(5) - Counter blade
(6) - Screw
To Next Page
Loading...
