To Next Page

To Previous Page

Programming

102 Service Instructions 867-M PREMIUM - 03.0 - 05/2017

A further branching into the submenus cannot be shown here for reasons

of space. A corresponding overview of the menu items appears at the be-

ginning of each chapter.

20.3 Parameter selection (ParameterCall) submenu

The submenu is visible only if the ParameterView parameter ( p. 119)

is active. The settings for a parameter can be changed directly here.

To change the parameters:

1. Select the menu item Service > ParameterCall.

2. Press the OK button to confirm the selection.

 A window appears where the parameter can be selected:

Fig. 90: ParameterCall submenu

3. Select the level of the desired parameter with the ▲/▼ buttons.

4. Use the

► button to move to the Cat category and select the desired

value with the

▲/▼ buttons or the number keys. The categories are

explained in the  Parameter list 867-M PREMIUM.

5. Use the

► button to move to the Par parameter and select the desired

value with the

▲/▼ buttons or the number keys. The parameters are

explained in the  Parameter list 867-M PREMIUM.

6. Use the

► button to move to the fourth value on the far right. This value

may vary, depending on the parameter. It may be a mode or a window

with an action selection.

7. Enter parameter value and confirm by pressing OK.

Abbreviation Meaning

OOperator

T Technician

ParameterCall

Cat Par Mode

01 00 6

Lvl

DURKOPP ADLER 867-M Premium Service Instructions

Other manuals for DURKOPP ADLER 867-M Premium