Programming
Service Instructions 867-M PREMIUM - 03.0 - 05/2017 105
20.4.5 Setting the Start bartack parameter (Start Tack)
Setting whether the start bartack is automatically activated in a new program.
20.4.6 Set End bartack parameter (End Tack)
Setting whether the end bartack is automatically activated in a new program.
20.4.7 Setting the Thread cutter parameter (Thread Trim)
Setting whether the thread cutter is automatically activated in a new pro-
gram or not.
20.4.8 Setting the daily piece counter (DailyPieces) parameter
The daily pieces counter can count upward or downward. It is also possi-
ble to enter the value to be selected when the counter is reset.
Menu item Setting option
ON The start bartack is activated automatically. The values for the start
bartack are taken from the Manual mode.
OFF The start bartack is not activated.
Menu item Setting option
ON The end bartack is activated automatically. The values for the end
bartack are taken from the Manual mode.
OFF The end bartack is not activated.
Menu item Setting option
ON The thread cutter is activated automatically at the end of a seam
section and at the end of the sewing program.
OFF The thread cutter is not activated.
Menu item Setting option
Cnt Mode OFF – the counter is off
Up – the daily pieces counter counts upward
Down – the daily pieces counter counts downward
Reset Enter the value to which the daily pieces counter should return when it
is reset (value range -999 - 999).
To Next Page
Loading...
Need help?
General
