DURKOPP ADLER 867-M Premium - Disassembling the Encoder

Integrated motor
Service Instructions 867-M PREMIUM - 03.0 - 05/2017 93
To remove the cover:
1. Loosen all 5 screws (1).
2. Remove the cover (2) from the side.
19.2.3 Disassembling the encoder
Fig. 79: Disassembling the encoder
To disassemble the encoder:
1. Unscrew the retaining plate (3).
2. Loosen both screws on the encoder (2).
3. Undo the screw on the encoder disk (1).
4. Carefully and uniformly pull the encoder (2) and encoder disk (1) away
from the shaft.
(1) - Encoder disk
(2) - Encoder
(3) - Retaining plate
①
②
③