Integrated motor
Service Instructions 867-M PREMIUM - 03.0 - 05/2017 95
To disassemble the rotor:
1. Remove the arm cover ( p. 17).
2. Loosen the threaded pins (1), (2).
3. Remove the rotor with deep groove ball bearing (3).
19.3 Assembling the drive
19.3.1 Assembling the rotor
Fig. 82: Assembling the rotor
To fit the rotor:
1. Push the rotor with deep groove ball bearing (3) onto the shaft until the
deep groove ball bearing is resting against the stop.
2. Screw all threaded pins (1), (2) firmly in place, observing the surface
of the shaft in doing so: Screw the first screw in the direction of rotation
firmly in place on the surface.
(1) - Threaded pins
(2) - Threaded pins
(3) - Rotor with deep groove ball bearing
To Next Page
Loading...
Need help?
General
