Programming
122 Service Instructions 867-M PREMIUM - 03.0 - 05/2017
A mode can be allocated to every output (parameter T 56 00).
The following table lists the modes:
20.6.5 Setting the Stitch functions (StitchFunctions) parameter
The machine counts the stitches when a program is processed with the
pedal. If the operator sews half stitches or full stitches manually, they can
also be counted, if required. To do so, this function must be active.
The electronic handwheel is not affected by this setting.
Mode Function
0 No function
1 Needle cooling
2 Cleaning signal for the residual thread monitor
3 Pos 1 (needle down)
4 Pos 2 (top of stroke)
5 Motor running signal
6 Puller/seam center guide
7 Sewing foot lift signal
To Next Page
Loading...
