DURKOPP ADLER M-Type Delta D867 - Page 101

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 99
First bartack section
The 1
st
section of the bartack can be
programmed with a different number of
stitches. All subsequent sections have
the preset number of stitches from the
settings for the start bartack.
On/Off
Number of stitches
Value range
01 - 50
Last bartack section
The last section of the bartack can be
programmed with a different number
of stitches. All previous sections have
the preset number of stitches from the
settings for the end bartack.
On/Off
Number of stitches
Value range
01 - 50
Invert bartack direction
Normally, a bartack starts either with
the sewing direction (forwards – even
number of sections) or against the
sewing direction (backwards – odd
number of sections), depending on
the number of sections.
Setting this parameter inverts the
sewing direction of the bartack.
Value range
On/Off
Icon Parameter Setting