DURKOPP ADLER M-Type Delta D867 - Setting the Parameters

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 81
Default status bar settings
Fig. 53: Default status bar
5.6.2 Setting the parameters
In Manual mode, you can set a variety of parameters. The functions
and how they affect the parameters are described further below.
To access the parameter settings:
1. Tap the symbol to bring up the parameter pane.
 This opens the parameter settings interface.
Material thickness
detection
Seam Length
Stitch count
Distance
edge guide
(if available)
Sewing speed
Empty