Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 107
Possible actions in the course of the seam
The following table lists the functions that can be performed in
the course of the seam.
5.7.2 Canceling a program in Automatic mode
To cancel a program in Automatic mode:
1. Push the pedal fully back.
The program is canceled and the thread cut. The machine
takes note of where the program was canceled, and then
continues from the same point when sewing resumes.
2. To cancel the program completely, press the pedal all the way
backwards again.
The program is canceled, and the machine starts from the
first seam section in the program when sewing resumes.
Important
Canceling by pedal is only possible if the parameter segment
switch by pedal is NOT active in the program defaults at the
Technician level.
If the parameter is still active, you can cancel the program only
by tapping the cross on the control panel.
Button/Pedal Function
Go to the next or previous step in the seams/ segments
Push the
pedal halfway
back
Lift sewing foot.
Push the
pedal fully
back or cancel
by tapping
the X
Cut off or cancel the program.
The program remains stopped at the cutoff point.
To Next Page
Loading...
