Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 111
5.8.4 Managing segments
You can create, delete and copy segments. Managing the items
is quick and easy thanks to the buttons listed below.
5.8.5 Setting program parameters
There are various options for setting the cross-program parame-
ters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Edit segments
Add segment
Delete segment
Copy and insert a segment
Icon Parameter Setting
Additional values (+)
Additional value stitch
length (+)
The 2
nd
value for the stitch length can
be switched on using a button on the
push button panel or the tile on the
control panel.
Value range
00.0 - 12.0
(depending on sewing equipment
and subclass)
Additional value sewing foot
stroke (+)
The 2
nd
value for the sewing foot
stroke can be switched on using a but-
ton on the push button panel, the knee
button or the tile on the control panel.
Value range
05.0 - 09.0 [mm]
Additional value needle
thread tension (+)
The 2
nd
value for the needle thread
tension can be switched on using a
button on the push button panel or
the tile on the control panel.
Value range
01 - 99
To Next Page
Loading...
