DURKOPP ADLER M-Type Delta D867 - Inserting changing the needle

Operation
20 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
4.2 Switching on and off the machine
Fig. 2: Switching on and off the machine
Switching on the machine
To switch on the machine:
1. Press the switch (2) on the rear of the control to position I.
 The button (1) on the front of the control illuminates red.
2. Tap the button (1) on the front of the control.
 The control and the control panel of the machine start up.
3. Press the pedal backwards when prompted to do so on
the display.
 The machine performs a reference run and is afterwards
ready for sewing.
Switching off the machine
To switch off the machine:
1. Press the button (1) on the front of the machine.
 Control and control panel shut down and are set to standby;
the button (1) illuminates red.
2. If necessary, press the switch (2) on the rear of the control
to position O.
 The machine is no longer set to standby.
(1) - Button (2) - Switch
①②