Programming Commander DELTA
100 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
5.6.5 Setting the Segment parameters
There are various options for setting the parameters in the
segment. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Icon Parameter Setting
Seam Parameter
Stitch length Value range
00.0 - 12.0 [mm]
(depending on the sewing equipment
and the subclass)
Needle thread tension Value range
01 - 99
Sewing foot pressure Value range
01 - 20
Sewing foot stroke Value range
1.0 – 9.0 [mm]
Max. Speed
It is possible to reduce the maximum
sewing speed at this point. The value
of the maximum sewing speed can be
set in the software at the Technician
level.
Value range
0050 – 3800 [rpm]
(depending on subclass)
Sewing foot lift at stop Value range
On/Off
Height of sewing foot lift
at Sewing stop
Value range
00 – 20 [mm]
(depending on subclass)
Light barrier
(optional additional equipment)
The light barrier detects the beginning
and the end of the material. After a
signal was detected, sewing can
continue automatically with the
specifically set parameters.
Value range
On/Off
(see p. 130)
To Next Page
Loading...
