Maintenance
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 143
To lubricate the hook:
1. Turn the screw (1):
• counterclockwise: more oil is released
• clockwise: less oil is released
Important
The released amount of oil does not change until the operating
time has run a few minutes. Sew for several minutes before you
check the setting again.
6.3 Servicing the pneumatic system
6.3.1 Setting the operating pressure
Proper setting
Refer to the Technical data ( p. 195) chapter for the
permissible operating pressure. The operating pressure cannot
deviate by more than ± 0.5 bar.
Check the operating pressure on a daily basis.
NOTICE
Property damage from incorrect setting!
Incorrect operating pressure can result in damage to the
machine.
Ensure that the machine is only used when the operating
pressure is set correctly.
To Next Page
Loading...
