Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 131
5.8.7.2 Setting the Outputs (Output) parameter
This parameter provides virtual outputs that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the
machine.
These parameters cannot be used unless the virtual outputs have
been assigned to a physical output at the Technician level. This
requires that the parameter Additional I/O Configuration
be configured at the Technician level; for more details, refer to the
explanation in the Service Instructions.
5.8.8 Setting the Segment End/Seam End parameters
There are various options for setting the parameters at the
segment end. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Icon Parameter Setting
Parameter Seam End
Sewing stop Value range
On/Off
Setting as to what will happen at
the end of a segment/seam.
(see p. 134)
Adjustments for seam end bartack parameters
Bartack at seam end Value range
On/Off
Number of stitches backwards Value range
01 - 50
Number of stitches forward Value range
01 - 50
To Next Page
Loading...
