DURKOPP ADLER M-Type Delta D867 - Setting the Segment End Parameters

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 101
5.6.6 Setting the Segment End parameters
There are various options for setting the parameters at the
segment end. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Icon Parameter Setting
Parameter Seam End
Sewing foot lift after trim Value range
On/Off
Height of sewing foot lift after
trim
Value range
00–20[mm]
(depending on subclass)
Thread trimmer Value range
On/Off
End bartack parameters
Bartack at seam end Value range
On/Off
Number of stitches backwards Value range
01 - 50
Number of stitches forward Value range
01 - 50
Number of bartack sections
A bartack consists of several sections. If the
sewing direction is changed, a new section is
started. The number of sections in a bartack can
be set here.
Value range
01 - 99
Stop-Time for direction change
The waiting time at the turning points (for exam-
ple for a change of sewing direction) is set at this
point. A short waiting time in milliseconds should
ensure consistent seam quality
(ornamental-stitch bartack).
Value range
0000 – 1000 [ms]