DURKOPP ADLER M-Type Delta D867 - Importing;Exporting Programs

Programming Commander DELTA
134 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
5.8.8.1 Setting the Sewing stop parameters
You can set additional parameters for the Sewing stop. Possible
settings and the corresponding value ranges are listed in the table.
5.9 Importing/exporting programs
Programs cannot be imported or exported by the Default User.
This process requires that the user be logged in as a technician,
 Service Instructions.
Icon Menu item Setting option
Needle up position Value range
On/Off
Thread trimmer
(can only be set in the last
segment)
Value range
On/Off
Sewing foot lift at
segment end
Value range
On/Off
High sewing foot
lift after thread
cutting/at segment
end
Value range 00 – 20 [mm]
(depending on subclass)