Setup
154 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
7.6 Setting the working height
The working height is continuously adjustable between
750 and 900 mm (clearance between the floor and upper edge
of the tabletop).
Fig. 72: Setting the working height
WARNING
Risk of injury from moving parts!
The tabletop can sink under its own weight when
the screws on the stand bars are loosened.
Crushing possible.
Ensure that your hands are not jammed when
loosening the screws.
CAUTION
Risk of musculoskeletal damage from
incorrect setting!
The operator can sustain musculoskeletal
damage if failing to comply with the ergonomic
requirements.
Adjust the working height to the body height of
the person who will operate the machine.
(1) - Screws
To Next Page
Loading...
