DURKOPP ADLER M-Type Delta D867 - Setting the Seam Begin;Segment Begin Parameters

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 125
Setting options Max. sewing speed
5.8.6 Setting the Seam Begin/Segment Begin
parameters
There are various options for setting the Seam Begin/Segment
Begin parameters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Menu item Setting 1 Setting 2
linear Max.
sewing speed
Value range 0000 – 4000
Maximum speed reached
at the upper material
thickness limit.
Min. Material thickness
Value range 00.0 – 10.0 [mm]
Material thickness at
which the increase in
sewing speed should
start.
Max. Material thickness
Value range 00.0 – 10.0 [mm]
Material thickness up to
which the increase in
sewing speed should
occur.
Icon Parameter Setting
Seam begin bartack parameters
Bartack at seam begin Value range
On/Off
Number of stitches backwards Value range
01 - 50
Number of stitches forward Value range
01 - 50
Number of bartack sections
A bartack consists of several sections.
If the sewing direction is changed, a new
section is started. The number of sections
in a bartack can be set here.
Value range
01 - 99