DURKOPP ADLER M-Type Delta D867 - Editing the Segments of a Seam

Programming Commander DELTA
110 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
5.8.3 Editing the segments of a seam
This section allows you to set the parameters for the current seam.
To edit the segments of a seam:
1. Tap on the desired seam.
 The seam is highlighted in blue.
Fig. 60: Editing the segments of a seam (1)
2. Tap on the symbol .
 The interface used for setting the parameters opens:
Fig. 61: Editing the segments of a seam (2)
(1) - Manage segments
(2) - Parameters cross-segment
(3) - Parameters Segment
(4) - Parameters Segment End/
Seam end
(5) - Parameters Segment Begin/
Seam Begin
(6) - List of adjustable parameters
①
②
⑤④③
⑥