Setup
164 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Fig. 81: Establishing equipotential bonding
To establish equipotential bonding:
1. Tilt the machine head.
2. Feed the equipotential bonding cable from the connection (1)
on the rear side of the control through the slot in the tabletop
and fix it in place at the connection of the base plate (2).
7.13.2 Connecting the control
To connect the control:
1. Connect the control as specified in the wiring diagram
( p. 197).
(1) - Control connection (2) - Base plate connection
DANGER
Risk of death from live components!
Unprotected contact with electricity can result
in serious injuries or death.
Disconnect the power plug before connecting
the control. Ensure the power plug cannot be
unintentionally reinserted.
To Next Page
Loading...
