DURKOPP ADLER M-Type Delta D867 - Setting Cross-Segment Parameters

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 83
5.6.3 Setting cross-segment parameters
There are various options for setting the cross-segment
parameters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Icon Parameter Setting
Additional values (+)
Additional value stitch length (+)
The 2
nd
value for the stitch length can be
switched on using a button on the push button
panel or the tile on the control panel.
Value range
00.0 - 12.0
(depending on sewing
equipment and subclass)
Additional value sewing foot
stroke (+)
The 2
nd
value for the sewing foot stroke can
be switched on using a button on the push
button panel, the knee button or the tile on the
control panel.
Value range
05.0 - 09.0 [mm]
Additional value needle thread
tension (+)
The 2
nd
value for the needle thread tension
can be switched on using a button on the
push button panel or the tile on the control
panel.
Value range
01 - 99
Gap (2
nd
value)
The 2
nd
value for the gap between the motor
driven edge guide and the needle (factoring in
the defined safety distance to the sewing
feet).
Value range
1.0 - 45.0
(depends on the sewing
equipment)
Main Parameter
Bobbin monitor mode (see  p. 86)
Point position
The distance of the needle from the material
can be adjusted to allow precise positioning of
the sewing material when starting sewing.
The value entered here corresponds to the
degree number on the handwheel.
Value range
000–359 [°]