DURKOPP ADLER M-Type Delta D867 - Setting the Segment Begin Parameters

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 97
5.6.4 Setting the Segment Begin parameters
There are various options for setting the Segment Begin
parameters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Icon Parameter Setting
Parameter Seam Begin
Needle thread clamp
The needle thread clamp is closed at
the 1
st
stitch of the seam to ensure that
the needle thread lies on the underside
of the sewing material
Value range
On/Off
Seam begin bartack settings
Bartack at seam begin Value range
On/Off
Number of stitches backwards Value range
01 - 50
Number of stitches forward Value range
01 - 50
Number of bartack sections
A bartack consists of several sections.
If the sewing direction is changed, a
new section is started. The number of
sections in a bartack can be set here.
Value range
01 - 99
Stop-Time for direction
change
The waiting time at the turning points
(for example for a change of sewing
direction) is set at this point. A short
waiting time in milliseconds should
ensure consistent seam quality
(ornamental-stitch bartack)
Value range
0000 – 1000 [ms]