Programming Commander DELTA
96 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Setting options Max. sewing speed
5.6.3.4 Setting the Outputs (Output) parameter
This parameter provides virtual outputs that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the
machine.
These parameters cannot be used unless the virtual outputs
have been assigned to a physical output at the Technician level.
This requires that the parameter Additional I/O Configu-
ration be configured at the Technician level; for more details,
refer to the explanation in the Service Instructions.
Menu item Setting 1 Setting 2
linear Max.
sewing speed
Value range 0000 – 4000
Maximum speed reached
at the upper material
thickness limit.
Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness at which
the increase in sewing
speed should start.
Max. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness up to
which the increase in
sewing speed should
occur.
To Next Page
Loading...
