Setup
158 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
7.9 Assembling the tilt sensor
Fig. 76: Assembling the tilt sensor (1)
Install the tilt sensor as follows:
1. Tilt the machine head.
The sensor (1) has been pre-assembled on the machine
head.
The magnet (2) and wood screws are in the bag that contains
the bobbins.
2. Use the wood screws to tighten the magnet (2) on the edge (3)
in the tabletop cutout ( p. 214).
Tighten the magnet (2) approx. 1 mm below the edge of
the table.
(1) - Sensor
(2) - Magnet
(3) - Edge
To Next Page
Loading...
