Operation
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 35
4.6 Winding the hook thread
The hook thread can be wound on without sewing.
Important
Never use the winder without a bobbin. If using it without a bobbin,
you run the risk of the thread winding itself around the bobbin
shaft, which may cause damage to the winder.
To wind the hook thread:
1. Fit the thread reel on the reel stand.
The unwinding bracket must stand directly above the thread
reel.
2. Feed the thread from the rear to the front through the thread
guide on the unwinding bracket.
WARNING
R i s k o f i n j u ry f r o m n ee d l e t i p a nd m o v i n g pa r t s !
Puncture, cutting and crushing possible.
Turn off the machine before threading the thread.
To Next Page
Loading...
