Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 103
5.6.7 Using bobbin wind mode
A bobbin can be wound without sewing. You can choose if you
want the winding process to stop automatically when the bobbin
is full or not until the bobbin shaft has completed a certain number
of rotations.
To use bobbin wind mode:
1. When setting up the user interface ( p. 78), drag the tile
for bobbin wind mode onto the main screen.
2. Tap to return to Manual mode.
3. Tap on the bobbin wind mode symbol and choose between
Lever and Rotations.
4. Define and confirm the settings.
Bobbin wind mode begins.
First bartack section
The 1
st
section of the bartack can be programmed
with a different number of stitches. All subsequent
sections have the preset number of stitches from
the settings for the start bartack.
On/Off
Number of stitches
Value range
01 - 50
Last bartack section
The last section of the bartack can be programmed
with a different number of stitches. All previous
sections have the preset number of stitches from
the settings for the end bartack.
On/Off
Number of stitches
Value range
01 - 50
Invert bartack direction
Normally, a bartack starts either with the sewing
direction (forwards – even number of sections)
or against the sewing direction (backwards – odd
number of sections), depending on the number
of sections.
Setting this parameter inverts the sewing
direction of the bartack.
Value range
On/Off
Icon Parameter Setting
To Next Page
Loading...
