DURKOPP ADLER M-Type Delta D867 - Page 97

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 95
Setting options Needle thread tension
Setting options Sewing foot pressure
Menu item Setting 1 Setting 2
linear Needle thread tension
Value range 00 – 99
Maximum needle thread
tension reached at the
upper material thickness
limit.
Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness at which
the increase in needle
thread tension should start.
Max. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness up to
which the increase in
needle thread tension
should occur.
2.OnOff Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness from
which the 2
nd
needle
thread tension should be
used.
2.On Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness from
which the 2
nd
needle
thread tension should be
used.
Menu item Setting 1 Setting 2
linear Sewing foot pressure
Value range 00 – 20
Maximum sewing foot
pressure reached at the
upper material thickness
limit.
Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness at which
the increase in sewing foot
pressure should start.
Max. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness up to
which the increase in
sewing foot pressure
should occur.