DURKOPP ADLER M-Type Delta D867 - Page 96

Programming Commander DELTA
94 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Setting options Stitch length
Menu item Setting 1 Setting 2
linear Stitch length
Value range -50 – 50 [%]
Maximum stitch length
variation reached at the
upper material thickness
limit.
Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness at which
the increase/reduction of
stitch length should start.
Max. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness up to
which the increase/
reduction of stitch length
should occur.
2.OnOff Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness from
which the 2
nd
stitch length
should be used.
2.On Min. Material
thickness
Value range 00.0 – 10.0 [mm]
Material thickness from
which the 2
nd
stitch length
should be used.