Programming Commander DELTA
84 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Gap
Value for the gap between the motor driven
edge guide and the needle (factoring in the
defined safety distance to the sewing feet).
Value range
1.0 - 45.0
(depends on the sewing
equipment)
Correction speed effect
Correction speed effect Value range
On/Off
(see p. 88)
Stitch length The stitch length changes
slightly depending on the
speed. For this reason, the
stitch length can be adjusted
at different speeds by the
software.
Needle thread tension Depending on the speed, the
needle thread tension can be
adjusted at different speeds
by the software.
Sewing foot pressure Depending on the speed, the
sewing foot pressure can be
adjusted at different speeds
by the software.
Material thickness detection
Material thickness detection Value range
On/Off
(see p. 92)
Sewing foot stroke The sewing foot stroke can be
adjusted to different material
thicknesses by the software.
Stitch length The stitch length changes
slightly depending on the
material thickness. For this
reason, the stitch length can
be adjusted to different
material thicknesses by the
software.
Icon Parameter Setting
To Next Page
Loading...
