Programming Commander DELTA
132 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Number of bartack sections
A bartack consists of several sections.
If the sewing direction is changed, a new
section is started. The number of sections
in a bartack can be set here.
Value range
01 - 99
Stop-Time for direction change
The waiting time at the turning points (for
example for a change of sewing direction)
is set at this point. A short waiting time in
milliseconds should ensure consistent
seam quality (ornamental-stitch bartack).
Value range
0000 – 1000 [ms]
Stitch length default
If this function is active, the same stitch
length is used for the bartack as the one
set in Manual mode. If this function is
deactivated, a custom input can be
entered.
On/Off
Stitch length of stitches
forward
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Stitch length of
backwards stitches
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Speed in bartack Value range
0000 - 2000
Single stitches per pedal
If this function is activated, each stitch in
the bartack can be sewn individually by
pressing the pedal. This function can only
be used meaningfully if the speed is set
very low for the bartack.
Value range
On/Off
Needle thread tension default
If this function is active, the same needle
thread tension is used for the bartack as
the one set in Manual mode. If this function
is deactivated, a custom input can be
entered.
Value range
On/Off
Icon Parameter Setting
To Next Page
Loading...
