Setup
160 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Fig. 78: Changing the handwheel
To change the handwheel:
1. Loosen the screws (3).
2. Remove the large handwheel (1).
3. Position the small handwheel (5) above the pulley in such a
way that the pin (4) protruding on the inside of the handwheel
fits into the matching hole (2) in the pulley.
4. Tighten the small handwheel (5) using the screws (3).
5. Place the cover (6) and tighten it using the screws (7).
6. The handwheel has been changed.
(1) - Large handwheel
(2) - Hole
(3) - Screws
(4) - Pin
(5) - Small handwheel
(6) - Cover
(7) - Screws
To Next Page
Loading...
