DURKOPP ADLER M-Type Delta D867 - Page 4

Table of Contents
2 Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
5.2.3 Navigating the burger menu ................................................................55
5.2.4 Navigation during the start of the control panel...................................55
5.3 User Configuration ..............................................................................56
5.3.1 Setting the language ...........................................................................57
5.3.2 Setting the brightness..........................................................................58
5.3.3 Setting the volume...............................................................................58
5.3.4 User Management administration .......................................................59
5.3.5 Setting the fast menu key configuration ..............................................59
5.3.6 Setting the screen configuration..........................................................61
5.4 User Management...............................................................................61
5.4.1 Authorizations as Default Technician ........................................65
5.4.2 User login ............................................................................................73
5.5 Software operating modes ..................................................................76
5.6 Using Manual mode ............................................................................77
5.6.1 Setting up the user interface ...............................................................78
5.6.2 Setting the parameters........................................................................81
5.6.3 Setting cross-segment parameters .................................................83
5.6.4 Setting the Segment Begin parameters...........................................97
5.6.5 Setting the Segment parameters ......................................................100
5.6.6 Setting the Segment End parameters .............................................101
5.6.7 Using bobbin wind mode ...................................................................103
5.7 Using Automatic mode ......................................................................104
5.7.1 Sewing in Automatic mode................................................................106
5.7.2 Canceling a program in Automatic mode ..........................................107
5.8 Using Programming mode.................................................................108
5.8.1 Managing programs ..........................................................................109
5.8.2 Managing seams ...............................................................................109
5.8.3 Editing the segments of a seam ........................................................110
5.8.4 Managing segments ..........................................................................111
5.8.5 Setting program parameters..............................................................111
5.8.6 Setting the Seam Begin/Segment Begin parameters .................125
5.8.7 Setting the Segment parameters ......................................................128
5.8.8 Setting the Segment End/Seam End parameters.......................... 131
5.9 Importing/exporting programs ...........................................................134
5.10 Performing a software update ...........................................................135
6 Maintenance..................................................................................... 137
6.1 Cleaning ............................................................................................138
6.2 Lubricating.........................................................................................140
6.2.1 Lubricating the machine head ...........................................................141
6.2.2 Lubricating the hook ..........................................................................142
6.3 Servicing the pneumatic system
........................................................143
6.3.1 Setting the operating pressure ..........................................................143
6.3.2 Draining the water-oil mixture............................................................ 144
6.3.3 Cleaning the filter element.................................................................146