Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019 69
Edit Seam Center Guide
Automatic mode
Access Program selection
Edit Program
Edit Stitch length correction factor
Edit Needle thread tension correction factor
Sewing
Access Submenu Start bartack
Access Submenu End bartack
Access Submenu Sewing foot lift
Access Submenu Thread clamp
Access Submenu Initial alignment stitch
Access Submenu Gap (additional value)
Access Submenu Reset Bobbin Counter
Access Submenu Reset daily piece counter
Access Seam Center Guide activated
User Management
Edit Current user
Read/Edit/Access Menu item
To Next Page
Loading...
