Introduction
4812164901_A.pdf 2022-11-14
Read the entire manual before starting
the machine and before carrying out
any maintenance.
Read the entire manual before starting
the machine and before carrying out
any maintenance.
Replace immediately the instruction manuals if
lost, damaged or unreadable.
Replace immediately the instruction manuals if
lost, damaged or unreadable.
Only the operator is allowed to be on the roller.Only the operator is allowed to be on the roller.
The motors are made with powerful magnets.
Users who are sensitive to magnetic fields
should avoid using or handling the motors.
The motors are made with powerful magnets.
Users who are sensitive to magnetic fields
should avoid using or handling the motors.
General
This manual contains instructions for machine
operation and maintenance.
The machine must be correctly maintained for
maximal performance.
The machine should be kept clean so that any
leakages, loose bolts and loose connections are
discovered at as early a point in time as possible.
Inspect the machine every day, before starting.
Inspect the entire machine so that any leakages or
other faults are detected.
Check the ground under the machine. Leakages are
more easily detected on the ground than on the
machine itself.
If faults or suspected damage are detected on the
roller, contact the responsible supervisor for any action.
THINK ENVIRONMENT ! Do not release oil
and other environmentally hazardous
substances into the environment. Always send
used filters, drain oil and any residue to
environmentally correct disposal.
THINK ENVIRONMENT ! Do not release oil
and other environmentally hazardous
substances into the environment. Always send
used filters, drain oil and any residue to
environmentally correct disposal.
This manual contains instructions for periodic
maintenance, where maintenance after every
10 and 50 hours of operation can be performed
by the machine operator.
The inspections of the battery, every and every two
months, carried out by the operator of the machine.
Other maintenance intervals must be carried out by
accredited (Dynapac) service personnel.
2
To Next Page
Loading...
