Dynapac CC900 e - Operation; Before Starting; Battery Charging, Battery Charger, 1-Phase (100-240 V)

Operation
4812164901_A.pdf2022-11-14
Operation
Before starting
Battery charging, battery charger, 1-phase
(100–240V)
Charging procedure
1
Fig. Frame left side
1. Charging socket
Connect the charger’s charging cable to the charging
socket on the machine (1).
Connect the charger’s 1-phase plug to the wall socket.
Fig. Control panel
1. Battery ON/OFF
1
Start the battery using the battery switch (1) on the
panel, press and hold the switch down for ~2 seconds.
57