Dynapac CC900 e - Transportation

Machine description
4812164901_A.pdf 2022-11-14
Power source (Battery system)
Safety
Intended use
This battery system is designed as power supply for
Dynapac CC900 e and Dynapac CC1000 e. The
battery system must not be used in any other
applications. Any other use is considered as misuse
resulting in invalidity of warranty
Safety instructions
General safety instructions
Read this manual carefully and make sure you
understand the instructions before starting any
work on the machine. No work is allowed to be
done on the battery system itself. Obey all the
instructions.
Read this manual carefully and make sure you
understand the instructions before starting any
work on the machine. No work is allowed to be
done on the battery system itself. Obey all the
instructions.
Wear eye protection, protective gloves, and
safety footwear when handling the battery
system.
Wear eye protection, protective gloves, and
safety footwear when handling the battery
system.
Safety instructions for welding
Do not weld on the battery pack.Do not weld on the battery pack.
Disconnect terminal cables before welding on
the machine.
Disconnect terminal cables before welding on
the machine.
Do not keep welding cables near battery cables
or over battery.
Do not keep welding cables near battery cables
or over battery.
NOTE! Recommended welding cable distance
from battery is 50 cm.
NOTE! Recommended welding cable distance
from battery is 50 cm.
42