Operation
4812164901_A.pdf2022-11-14
Braking
Service brake
Turn off the vibration using the buttons (1) and (2) on
the control lever.
4
3
Fig. Control panel
3. Forward/Reverse lever
4. Parking brake
Set the forward/reverse lever (3) in the neutral position
to stop the roller.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
Never leave the operator platform without
activating the parking brake (4).
Never leave the operator platform without
activating the parking brake (4).
Emergency brake
2
1
Fig. Control panel
1. Emergency stop
2. Forward/reverse lever
Braking is normally activated by using the
forward/reverse lever (2). The hydrostatic transmission
brakes the roller when the lever is moved to the
neutral position.
There is a brake on each drum motor that acts a
reserve brake when in motion, and as a parking brake
when stationary.
For reserve braking, press down the parking brake (1),
hold the steering wheel firmly and be prepared for a
sudden stop.
69
To Next Page
Loading...
