Dynapac D.ONE - Page 187

Fault description Cause Remedy
0561 Supply voltage Display value = voltage in V
Shows the voltage value Display value = voltage in V
Fault description Cause Remedy
0660 Switches on function "Set remote control type" See adjustment instructions
0661 confirms the entered remote control type See adjustment instructions
0662 Preselect radio remote control, default setting See adjustment instructions
Fault description Cause Remedy
0700 Switch on function „Show stored faults“ See adjustment instructions
0701 Switch off function "Show stored faults" See adjustment instructions
0710 Delete all stored faults See adjustment instructions
Fault description Cause Remedy
6000 Enable service mode 6000
6001 Service mode active, machine travels for 15min. without acti-
vated BOSS safety system. Attention: Only for servicing pur-
poses!
6001 = service mode
active
6002 Service mode inactive
Fault description Cause Remedy
7500 Display of hours, operating hour meter The full hours are displayed
7501 Display of minutes, operating hour meter The minute digits of the operating hour
meter are displayed
Fault description Cause Remedy
7010 Switches on function "Set machine type" See adjustment instructions
7011 Confirms entered machine type See adjustment instructions
Setting the remote control type
Fault log
BOSS safety system
Reading out the operating hour
meter
Setting the machine type
Appendix – Input codes for BLM control
D.ONE
187