D 9
D F6C.GB 9-50 0504
Item Designation Brief description
16
Reversing switch
for conveyor
The conveyor’s direction can be reverse separately for both
halves of the conveyor, in order to slightly reverse any materi-
al which may be positioned just in front of the auger. This ena-
bles the avoidance of e.g. material loss during
transportation.The conveyor covers a distance of approx. 0,5
meter towards the hopper.
If necessary, the switch can be actuated an arbitrary
number of times to reverse the conveyor over a longer
distance.
17
Conveyor
left/right
auto: switched on with drive lever and controlled via the
material limit switch in the tunnel
stop: Off
manual: permanently switched on (with full feed capacity,
without material control)
- To automatically operate the conveyor via the remote con-
trol, both switches must be set to „auto“.
18
Tamper
(screed-specific)
auto: switched on with drive lever switched off when at a
standstill
stop: completely switched off
manual: permanently switched on
As a rule, „auto“ is used for paving.
$
When the switch is set to „manual“ during paving, it
must be set to „stop“ when at a standstill. Otherwise,
excessive compacting occurs!
Speed control (see the section „Speed regulator,
tamper“).
19 Vibration
Operation and application: see switch (Tamper).
Speed control (see the section „Speed regulator, vibration“).
To Next Page
Loading...
