Dynapac F6C - Starting the Paver Finisher; Before Starting the Paver Finisher; Normal Starting

D 33
D F6C.GB 33-50 0504
3.2 Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and be-
ginning operation, the following steps
must be performed:
- Daily maintenance of the paver finish-
er (see chapter F)
$
Check the operating hour counter to de-
termine whether or not additional main-
tenance work (e.g. monthly or annual
maintenance) must be performed.
- Check the safety devices and protec-
tive devices.
„Normal“ starting
Set the drive lever (1) to the centre posi-
tion and the speed adjuster (2) to mini-
mum.
- Turn the ignition key (3) to position „1“.
The lights should be switched off dur-
ing starting to reduce the current drain
on the battery.

Starting is impossible when the traction
indicator lamp is lit (4) (drive lever (1) not
in central position) or the engine stop in-
dicator (5) is active (emergency stop button (6) is pressed, auger or conveyor switch
is switched on).
- Press the starter button (7) to start the engine. Do not let the starter run permanent-
ly for more than 10 seconds; allow for a break of 1minute after every attempt!
START
ON
OFF
Element2_F6C.cdr,Element3a_F6C.cdr,
5
4
2
3
1
7
6